How to replace leaf springs tacoma 2003

Remove the Tires Use a jack to lift the truck in the back and use safety stands to hold the vehicle in suspension.

In fact, many modern light-duty trucks have abandoned the design for comfort-oriented systems such as coil springs.

how to replace leaf springs tacoma 2003

Install the new leaf spring. Elevate the rear portion of the truck with a jack. There are high-tension springs that must be extended which are poised to mutilate your hands at the slightest lapse in concentration.

Email Twitter Posts.

how to replace leaf springs tacoma 2003

Get Your Tools In order to access this part of the vehicle, you will need to have the right tools at your disposal. Reapply the Wheel Manually fasten the link nuts until the stabilizer is tightly secure.

This way, the impact of speed bumps and road obstructions are softened before such motion can reach the cab. The leaf springs on my Tacoma had seen better days, so it was high time to change them out for new.

Turn the spring to loosen it from the rear shackle. However, the axle no longer moves an alarming or even a noticeable amount. Once you have the new leaf springs installed and the wheels reattached to the vehicle, lower the truck from the stands and take it out for a test drive.

how to replace leaf springs tacoma 2003

On the side with the leaf spring that needs be replaced, unscrew the lug nuts on the tire and perform the following steps:. Peter Monshizadeh Enjoys working on vehicles with poor reputations.

2002 Tacoma OME Dakar leaf

Also, there was a secondary issue I had gone in there for: Kinja is in read-only mode. I went ahead and used new U-bolts to secure the springs to the axle. If you still aren't sure how to proceed with replacing these parts, read on for a more detailed set of instructions on how to change leaf springs on Toyota Tacoma trucks.

2001-2004 Toyota Tacoma 4wd (Extra Cab) - Leaf Spring (Rear - 3/1 Leaves) [LEFT SIDE]

They are overly complicated compared to a conventional disc brake setup. Rocking can happen when one or both of the springs become weak.

how to replace leaf springs tacoma 2003

Now that all of these pieces have been cleared away, you can reach the leaf spring that you intend to replace. Inspect the Springs As you inspect each spring, you will need to determine whether the problem is down to one or both of the springs. With the new drums offered up, the whole rear end looked almost new.

Perhaps the most discomforting — heck, perhaps the most frightening — experience drivers and passengers could possibly experience in a Toyota Tacoma is when the vehicle abruptly jumps. This is because I wanted to retain decent ride quality and stock ride height. Peter Monshizadeh. Does the vehicle ride as it should?

The problem reaches down to the leaf springs, which break at disproportionate frequencies on this particular vehicle.

how to replace leaf springs tacoma 2003

Use a jack to lift the truck in the back and use safety stands to hold the vehicle in suspension.